Certified ISO9001:2015+AS9100D
Designed & Built in the U.S.A. | Used & Supported Worldwide

How Does Your Telemetry Receiver Compare?

  1. Home
  2. >
  3. Tech Tips
  4. >
  5. How Does Your Telemetry Receiver Compare?

FILTER

Suffering from near/far signal problems or adjacent channel interference with your telemetry receiver? Problem Solved!

GDP’s Model 4426 Telemetry Receiver has an exceptionally wide dynamic range, linear at the high end to +5dBm to
accommodate high power near field signals, yet with excellent sensitivity at the low end from a noise figure of better than 7dB – an 18dB improvement over your typical receiver!

With the 4426’s multi AGC/multi SAW filter superhet architecture, out-of-band signals are attenuated below the noise floor. In addition, with a completely tunable Digital IF filter, adjacent channel signals are attenuated by more than 60dB. Also available in 1U rackmount chassis.

Suffering from near/far signal problems or adjacent channel interference with your telemetry receiver? Problem Solved!

GDP’s Model 4426 Telemetry Receiver has an exceptionally wide dynamic range, linear at the high end to +5dBm to
accommodate high power near field signals, yet with excellent sensitivity at the low end from a noise figure of better than 7dB – an 18dB improvement over your typical receiver!

With the 4426’s multi AGC/multi SAW filter superhet architecture, out-of-band signals are attenuated below the noise floor. In addition, with a completely tunable Digital IF filter, adjacent channel signals are attenuated by more than 60dB. Also available in 1U rackmount chassis.

FILTER